Zephyr Net http://jkpeterson.net/forum/ |
|
Has anyone ever hex edited the FOG layers or CLOUD layers? http://jkpeterson.net/forum/viewtopic.php?f=6&t=2170 |
Page 1 of 1 |
Author: | CAG Hotshot [ Sat Jan 03, 2015 23:27 pm ] |
Post subject: | Has anyone ever hex edited the FOG layers or CLOUD layers? |
Has anyone ever edited either the FOG layer or the CLOUD layer files to change heights? These are the FOG1.LAY to FOG1V.LAY and CLOUD1.LAY etc... |
Author: | Zephyr [ Sun Jan 11, 2015 14:48 pm ] |
Post subject: | Re: Has anyone ever hex edited the FOG layers or CLOUD layer |
As far as I can remember, no. However, I seem to remember a lib where the high altitude clouds (I assume this is the CLOUD1.LAY) were at a lower altitude. I could be mixing that up with the scattered cloud layer which can be edited in the mission file. |
Author: | CAG Hotshot [ Sun Jan 11, 2015 23:48 pm ] |
Post subject: | Re: Has anyone ever hex edited the FOG layers or CLOUD layer |
After I get some of my libs released again I will take a look at them to see if I can alter the FOG and CLOUD layers... |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |